Starting A Warm Engine - Poulan Pro PPB100 Manual De Instrucciones

HOW TO STOP YOUR UNIT
• To stop the engine, move the ON/OFF
switch to the OFF position.
• If engine does not stop, move choke lever
to FULL CHOKE position.
6. Pull starter rope handle sharply until en-
gine sounds as if it is trying to start, but do
not pull rope more than 6 times.
7. As soon as engine sounds as if it is trying
to start, move choke lever to HALF
CHOKE by aligning lever with position
shown on decal (see illustration below).
,,...
ON/OFF Switch
HOW TO START YOUR UNIT
WARNING:
Avoid any contact with
the muffler. A hot muffler can cause serious
burns.
HELPFUL TIP
!f your engine still does not
! start after foflowll_g these
instructions, please call
1-800-554-6723.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
'S__ _'_'tarting Position
t&j
Primer Bulb
Choke
_Lever
Choke
position
decal
8. Pull starter rope sharply until engine runs,
but no more than 6 puIIs. If the engine
doesn't start after 6 puffs (at the HALF
CHOKE position), move the choke lever to
the FULL CHOKE position and press the
primer bulb 6 times. Squeeze and hold the
throttle trigger and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE position and pull the starter
robe until the engine runs, but no more than
6 pulis, if the engine doesn't start, repeat
procedure 2 additional times.
NOTE: If engine still doesn't start, it is
probably flooded. Proceed to STARTING A
FLOODED ENGINE.
9. Once the engine starts, altow it to run 10 se-
conds, then move the choke lever to OFF
CHOKE by aligning lever with position
shown on decal (see illustration below). Al-
low the unit to run for 30 more seconds at
OFF CHOKE before releasing the throttle
trigger. NOTE: If engine dies with the
choke lever in the OFF CHOKE position,
move the choke lever to the HALF CHOKE
position and pull the robe until engine runs,
but no more than 6 pulls.
Muffler
1. Set unit on a flat surface.
2. Move ON/OFF switch to the ON position.
3. Slowly press the primer bulb 6 times.
4. Move choke lever to FULL CHOKE by
aligning lever with position shown on de-
cal (see illustration below).
5. Squeeze the throttle trigger fully and hold
through all remaining steps.
Choke
position
decal
STARTING A WARM ENGINE
1. Move ON/OFF switch to the ON position.
2. Move the choke lever to the HALF
CHOKE position.
3. Squeeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
the engine runs smoothly.
4. Pullstarter rope sharply until engine runs,
but no more than 5 pulis.
5. Allow engine to run 15 seconds, then
movethe choke lever to the OFF CHOKE
position,
NOTE: if engine has not started, pull starter
rope 5 more pulls. If engine still does not run, it
is probably flooded.
9