Idiomas disponibles
Idiomas disponibles
BEFORE CALLING FOR SERVICE
Problem
Possible Causes
Wrinkling
• Washer not unloaded
• Washer overloaded.
• Hot and cold water inlet
Drum light does
• This is normal.
not stay on
The display shows:
• Load is too small.
• Load is out of balance.
• The washer has an imbalance
ERROR
LOAD IS OUT
OF BALANCE.
REARRANGE
WASH LOAD.
The display shows:
• Control error.
ERROR
SEE OWNER'S
MANUAL..
The display shows:
• Water level is too high due to
ERROR
SEE OWNER'S
MANUAL..
The display shows:
• The water level sensor is not
ERROR
SEE OWNER'S
MANUAL..
The display shows:
• Thermal overload protection
ERROR
SEE OWNER'S
MANUAL..
The display shows:
• A power failure has occurred.
ERROR
THE WASHER
EXPERIENCED A
POWER FAILURE.
RESTART THE
CYCLE.
(cont.)
promptly.
hoses are reversed.
detection and correction system.
If individual heavy articles are
loaded (bath mat, bath robe, etc.)
and the imbalance is too great,
the washer will make several
attempts to restart the spin cycle.
If an imbalance is still detected,
the washer will stop and the error
code will be displayed.
a faulty water valve.
working correctly.
circuit in the motor has been
tripped.
T RO U B L E S H O OT I N G
Solutions
• Always remove items from the washer as soon as
the cycle is completed.
• The washer can be fully loaded, but the drum should
not be tightly packed with items. The door
of the washer should close easily.
• Hot water rinse can set wrinkles in garments.
Check the inlet hose connections.
• The drum light shuts off automatically when the
washer starts. Press and hold the STAIN CARE
button for 3 seconds to turn on the light; it will turn
off automatically after 4 minutes.
• Add 1 or 2 similar items to help balance the load.
• Rearrange items to help balance the load.
• Unplug the washer and call for service.
• Close the water taps, unplug the washer, and call
for service.
• Close the water taps, unplug the washer, and call
for service.
• Allow the washer to stand for 30 minutes to allow the
motor to cool; then restart the cycle. If the LE error
code still appears, unplug the washer and call
for service.
• Restart the cycle.
33
