Idiomas disponibles
Idiomas disponibles
Identify the malfunction in accordance to Table 2 on page 18.
Follow Table 2 steps after inserting the TETRA Handportable
Terminal into the cradle and turning the ignition switch to ON.
No. Malfunction
1
Display
message
"Charger/
Holder
Connected"
does not exist.
2
Charging
Indication does
not exist.
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are
trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are
used under license. All other trademarks are the property of their respective owners.
© 2013 Motorola Solutions, Inc. All rights reserved.
Table 2: Troubleshooting Procedures
Corrective Action
1.
Remove the TETRA Handportable
Terminal from the cradle and install it
again.
2.
Check the cradle accessory connector.
Ensure the cradle is connected
properly.
1.
Verify that the ignition switch is in the
ON position.
2.
Check the power cable. Verify that the
red wire is connected to the positive (+)
terminal on the vehicle's battery, the
black wire is connected to the vehicle's
chassis and the blue wire is connected
to the ignition line.
3.
Check the fuses installed on the red
and blue wires. Verify their
serviceability and replace if required.
18
