Idiomas disponibles
Idiomas disponibles
ANTENNA KIT INSTALLATION
Use only a Motorola approved roof antenna and refer to the antenna
installation instruction provided in the antenna kit.
Avoid visual or physical obstruction, route the antenna cable down
inside the door moulding and beneath the carpets and seat(s). Allow
sufficient slack at the connector end of the cable to reach the cradle's
FME connector.
Position the antenna in such a way to maintain a separation distance
of at least 8 inches (20 cm) between the antenna connected to the
Car Kit and the body of any user, or nearby person, to assure
compliance with regulations on RF exposure.
Note:
Antennas with a gain exceeding 6db do not comply with
ETSI RF exposures and are not allowed to be used with this
product.
ROOFTOP COMBINED GPS/TETRA ANTENNA KIT
To install a combined GPS/TETRA antenna kit, refer to the
installation manual provided in the antenna kit and to the
explanations below.
KIT COMPONENTS
See Figure 9.
1.
Combined GPS/TETRA typical antenna
2.
5 m RG58 FME to unterminated loose FME cable, supplied in kit
3.
5 m RG174 MFME to FME cable
4.
Duplexer
5.
2.4 m DC Adapter Cable (FTN6790)
6.
1 m FME cable
Installation procedures
Install the kit components in the following suggested order:
1.
Antenna
2.
5 m RG58 FME to unterminated loose FME cable, supplied in kit
3.
5 m FME to FME RG58 RF cable
4.
Duplexer
5.
2.4 m DC Adapter Cable (FTN6790)
6.
1 m FME cable
13
