Idiomas disponibles
Idiomas disponibles
EN
28
Handle Installation Method
1
Take out handle from cabinet, then take out
four pcs 4*35 screws from accessory bag.
2
Pull open door seal from the side of door,
then insert screws into the 2 handle holes on
side of door, then put the screws alignment
the hole of handle , tighten the screws by
Phillips screwdriver then compress the door
seal
3
If the screws holes of the handle don't match
perfectly with the holes of the door, please
use the electric drill to drill the holes of the
door a bit big (in surface side), in order to
install the handle perfectly .
TROUBLESHOOTING
Problem
Possible Cause and Suggested Solution
Wine cellar
Not plugged in.
does not
The appliance is turned off.
operate.
The circuit breaker tripped or the fuse is broken.
Wine cellar
Check the temperature control setting.
is not cold
External environment may require a higher setting.
enough.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The light does
Not plugged in.
not work.
The circuit breaker tripped or a blown fuse.
The bulb is out of order.
The light button is "OFF".
