Idiomas disponibles
Idiomas disponibles
GB
Removal: to remove the canopy, push the lever outwards, pull and remove.
ATTACHMENT/REMOVAL OF SAFETY BAR (FIG. 5)
To attach the bumper bar to the frame, insert the two plastic ends of the bumper bar in the plastic
support as show in figure.
The bumper bar can be opened from one side or completely removed. To open it, press the two
buttons located on the bar and pull it towards you. To remove completely, repeat the operation on
the other side.
USE
LOCK/UNLOCK FRONT WHEEL SWIVEL (FIG.6)
The pushchair is fitted with swivelling front wheels which can be locked or unlocked by lifting or
lowering the lever on each wheel.
REAR WHEELS BRAKE (FIG.7a/7b)
The rear wheels have linked brakes, which can be applied simultaneously to the two rear wheels units
by using one pedal.
To apply the brakes, push one of the two levers located at the centre of the rear wheel units in a
downward direction, as shown in figure and lightly push the pushchair forward to check that the brake
has been properly applied.
To unlock the braking system, push one of the two levers located at the centre of the rear wheel units
in an upward direction, as show in figure.
Always engage the brake during stops.
ADJUSTING THE LEG REST (FIG.8)
The stroller's leg rest can be adjusted to offer extra comfort to your child. Press simultaneously the two
side buttons, as show in the figure, to adjust the leg rest.
BACKREST ADJUSTMENT (FIG.9)
Recline the backrest as shown in the photo by pulling the strap with one hand while holding and
pressing the adjuster toggle with the other hand. Slide the adjuster toggle along the strap to raise or
lower the backrest. Release the adjuster toggle to lock the backrest in the chosen position.
We recommend adjusting the backrest when there is no child seated in the pushchair.
IMPORTANT: For children under 6 months old, the backrest must always be in the most
reclined or horizontal position.
SAFETY HARNESS (FIG.10)
Apply the brake before placing the child.
Releasing the buckle: press the button and pull out the latches.
Place the child into the pushchair and adjust the harness to the child's size.
Attaching the buckle: Insert all the harness latches into the buckle. A click indicates correct insertion.
Always use the correctly attached restraint system.
FOLDING THE PUSHCHAIR (FIG.11a/11b/11c)
Before folding the pushchair, ALWAYS ensure that:
- the backrest is adjusted into the vertical position.
- the canopy is fully folded.
Slide the locking button to the left and squeeze the release bar simultaneously, lift the pushchair until
the frame is completely folded.
11
