Tc 1. Standard And Directives References; Tc 2. Hazards; Tc 3. Warnings - ThermoKey DFX Serie Manual De Instrucciones

ThermoKey Heat Exchange Solutions

TC 1. Standard and directives references

The product described in this manual is compliant with:
MACHINERY DIRECTIVE 2006/42/EC
LOW VOLTAGE DIRECTIVE 2014/35/EU
ELECTROMAGNETIC COMPATIBILITY DIRECTIVE 2014/30/EU
PED DIRECTIVE 2014/68/EU
ERP DIRECTIVE 2009/125/EC

TC 2. Hazards

Danger of electrocution. The product is fitted with electric fanmotors and electric defrosting heating elements with
nominal operational low three-phase or single-phase voltage. The electric power supply lines will have to use protection
systems against electric shock and protection equipment required by law.
Risk of burns. In products fitted with electric defrosting heating elements the surface temperatures of the external armor
can reach about 350 °C if left on without control.
Risk of cutting. The internal heat exchanger is made of metal fins with unprotected sharp edges. The casing is made of
metal sheet components that may have unprotected sharp edges.
Danger of moving parts. The product is fitted with electric fanmotors equipped with a protection grille as provided by
law. For some products, it may be possible to deliberately access moving parts (fanmotor blades) from non-protected areas.
Before any access make sure that the moving parts do not constitute a hazard to operators.
Danger of squashing limbs or persons. During handling, transportation and installation, operation and maintenance,
pay maximum attention to the indicated weight of each product to prevent tipping over or dangerous falls towards the
operators.
Danger of falling objects. The products are fitted with doors, trays or covering metal sheet parts that during installation
or maintenance may be dismounted by removing the fastening screws; please take all appropriate precautions.
07 MT TC A DF EN 04 2017

TC 3. Warnings

TC 3.1
Contents of the Product Technical Manual:
INSTRUCTIONS FOR SAFE USE (IG)
INSTRUCTIONS FOR HANDLING AND UNPACKING (IM)
INSTRUCTIONS AND TECHNICAL DATA (TC)
SPECIFIC INSTRUCTIONS FOR USE AND MAINTENANCE (IS)
TC 3.2
This manual is section TC, called INSTRUCTIONS AND TECHNICAL DATA, of the Product Technical Manual.
For any information not covered in this manual, please refer to the other sections (IG-IM-IS) and, if in doubt, contact
the Manufacturer.
TC 3.3
This manual is an integral part of the DFX DFB DFN and DFC units and as such it must be kept throughout the
operational life of the product.
TC 3.4
Any additional technical documentation relating to the non-standard products is attached to this manual becoming
an integral part of it and is identified with a specific code indicated on the shipping documents.
TC 3.5
The product described in this manual is considered a partly completed machine, therefore not usable as supplied, but
it is a component for air conditioning and refrigeration systems and must be installed and commissioned by qualified
operators (see the chapter related to installation and put in function).
TC 3.6
Each product is supplied with EC Declaration of Incorporation.
TC 3.7
Additional product documentation, consisting of catalogues, guides and technical bulletins, is provided directly
by ThermoKey and it is available on our website www.thermokey.com.
CATALOGUES – http://www.thermokey.com/Cataloghi.aspx
MANUALS – http://www.thermokey.com/Manuali.aspx
MT TC A DF EN 04 2017
Technical Manual TC Instruction and technical data
08