Idiomas disponibles
Idiomas disponibles
Anleitung_4309025:_
19.07.2010
GB/
MT
5. Proper use
The fretsaw was designed to cut square-edged
timber or wood-like workpieces such as
Plexiglas, glass fiber reinforced plastic, foam,
rubber, leather, and cork. Do not use this saw to
cut round materials. Round materials can easily
become jammed. Risk of injury! Parts can be
catapulted!
The equipment may only be used for the tasks it
is designed to handle. Any other use is deemed
to be a case of misuse. The user/operator and
not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the equipment is used in commercial,
trade or industrial businesses or for equivalent
purposes.
The equipment is to be operated only with
■
suitable saw blades. It is prohibited to use
any type of cutting-off wheel.
To use the equipment properly you must
■
also observe the safety information, the
assembly instructions and the operating
instructions to be found in this manual.
All persons who use and service the
■
equipment have to be acquainted with these
operating instructions and must be informed
about the equipment's potential hazards.
It is also imperative to observe the accident
■
prevention regulations in force in your area.
The same applies for the general rules of
■
health and safety at work.
The manufacturer will not be liable for any
■
changes made to the equipment nor for any
damage resulting from such changes.
Residual risks
Even if you use this electric power tool in
accordance to instructions, certain residual
risks cannot be eliminated. The following
hazards may arise in connection with the
equipment's construction and layout:
54
15:26 Uhr
Seite 54
Lung damage if no suitable protective dust
■
mask is applied
Damage to hearing if no suitable ear
■
protection is applied
Contact with the blade in the uncovered
■
cutting zone
Injuries (cuts) when changing the blade
■
Crushed fingers
■
Kickback
■
Tilting of the workpiece due to inadequate
■
support
Touching the blade
■
Catapulting of pieces of timber and
■
workpieces
6. Technical data
Mains voltage:
Power input:
Operating mode:
Idle speed n
:
0
Protection type:
Stroke:
Base area:
Tilting range of table:
Table size:
Length of saw blade:
Reach:
Max. cutting height at 90°:
Max. cutting height at 45°:
Weight:
Load factor
Rated operating period 5 min./rated idle period
5 min. A load factor of S2 5 min (intermittent
periodic duty) means that you may operate the
motor continuously at its nominal power level
(120 W) for no longer than the time stipulated
on the specifications label (5 minutes ON
period). If you fail to observe this time limit the
motor will overheat. During the OFF period the
motor will cool again to its starting temperature.
230 V ~ 50 Hz
120 W
S2 5 min
400 - 1,600 rpm
IP 20
21 mm
410 x 245 mm
0° to 45° to the left
410 x 253 mm
134 mm
406 mm
57 mm
32 mm
approx. 10.5 kg
