Idiomas disponibles
Idiomas disponibles
Determine the install location(s) for the waterfall. Be sure to follow all NEC and local codes during
installation. To achieve the proper water effect, it is recommended to install the waterfall no higher
than 3 feet above water level. The maximum cable run from the LED light to the low voltage swim-
ming pool transformer should not exceed 150 feet.
Mechanical
Refer to the diagram below for waterfall dimensions before roughing-in plumbing and electrical
lines. Note: Refer to page 14 for waterfall length dimensions and number of lights.
8.09"
Step 1: Rough-in plumbing and electrical lines. See overview diagram on page 5-6.
Step 2: Cut a notch in the bond beam and attach a board as shown below. Make sure the board
is level as it will be used for setting the level of the waterfall.
3
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2.08"
4.16"
14.00"
9.84"
1.85"
}
0.61"
4.47"
Position the board
0.625" below the top
of the bond beam. The
edge of the Waterfall
lip will rest on the top
of the board.
