Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
1. Shut off the unit including pilot. Allow the unit to cool for at least 30 minutes.
2. Inspect the burner, pilot and primary air inlet holes on orifice holder for dust and dirt (See Fig. 31).
3. Blow air through the ports/slots and holes in the burner.
4. Check the orifice holder located at the end of the burner tube again. Remove any large particles
of dust, dirt, lint or pet hair with a soft cloth or vacuum cleaner nozzle.
5. Blow air into the primary air holes on the orifice holder.
6. In case any large clumps of dust have now been pushed into the burner repeat steps 3 and 4.
Clean the pilot assembly also. A yellow tip on the pilot flame indicates dust and dirt in the pilot
assembly. There is a small pilot air inlet hole about 2" from where the pilot flame comes out of the
pilot assembly (see Figure 32). With the unit off, lightly blow air through the air inlet hole. You may
blow through a drinking straw if compressed air is not available.
Burner Orifice
Pilot Flame (NG)
Primary Air Inlet Hole
Burner Tube
Pilot Air Hole
Fig. 31 - Primary Air Inlet Slot
Fig. 32 - Pilot Inlet Air Hole
on Burner Tube
GLASS ROCKS
• If you remove the lava glass rocks for cleaning, refer to page 21, for placement instructions.
CABINET
Air Passageways
Use a vacuum cleaner or pressurized air to clean.
Exterior
Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust.
26
