Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
WARNING
The heater must be properly installed before it is used.
Power Indicator
Thermostat
(Yellow)
Selection
Caution Indicator
Switch
(Red)
SETTING THE THERMOSTAT
1) Rotate thermostat knob clockwise to high position, POWER INDICATOR will
turn yellow.
2) After room reaches desired comfort level rotate thermostat knob counter
clockwise until the thermostat to OFF position.
NOTE: Heater will cycle on and off to maintain room temperature.
SELECTION SWITCH
Using the SELECTION SWITCH, you can
I
II
control the heating output: I for 6250W, II for 7500W.
Selection Switch
THERMAL CUT-OUT
The heater will automatically shut off when parts of it overheat. The heater
will turn ON again when the abnormal temperature returns to normal levels.
Should the unit overheat and cause the thermal cut-out to cycle, the cause of
the overheating should be determined and corrective action taken before further
operation.
NOTE: When the thermal cut-out is activated, the caution indicator will turn red.
In this case, immediately turn the heater OFF and inspect for any objects on or
adjacent to the heater that may cause high temperatures. DO NOT OPERATE
THE HEATER WITH THE CAUTION INDICATOIR GLOWING RED.
10
