Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the bidet.
3. Slip the slide washer, washer and collar nut
over the threaded base and tighten the collar
nut by hand.
4. Tighten screws.
5. Connect the connecting hose to the angle
valves; cold right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
To adjust the hot water limiter on single lever
mixers, please see page 12.
No adjustment is necessary when using a
continuous flow water heater.
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(8a) located behind the mousseur must be removed.
6
English
Spare parts
1 lever head
1.1screw cover
2 flange
3 nut
4 service set
5 seals (5)
6 mixer ball
7 mixing unit cpl.
8 mousseur cpl. (10)
9 pull rod
10 fixation cpl.
11 connection hose
XXX = Colors
030 chrome/blue
060 chrome/black
070 chrome/green
330 blue
430 red
450 white
480 yellow
max. 10 bars
580 yellow/satin chrome
610 black
16 bars
max. 80° C
65° C
7 l/min 3 bars
13290X X X
94063X X X
94130X X X
94106000
13952000
13962000
13964000
14095000
13085000
92620X X X
13961000
94076X X X
