Idiomas disponibles
Idiomas disponibles
Assembly Instructions
Seat's Main Frame Assembly:
1. Place the seat bench upside down on top of a raised flat surface to reveal the pre-drilled holes and indentations for setting in the seat's
main frame.
2. You should have received a total of 9 hand screws, 5 short ones and 4 long ones (for G2-100KHX1).
3. Locate the imprinted "A" indentation on the underside of the bench. Insert the #A main frame into the preformed indentation labeled #A.
4. Locate the imprinted "B" indentation on the underside of the bench. Insert the #B main frame into the pre-formed #B indentation.
5. Secure the center cross section using curved washer and one of the five short hand screws.
6. Lay the bench on its side.
7. (For G2-200KHX1 only) Attach the reinforcement bars to the bottom of the bench. Use the 4 long hand screws to attach the
reinforcement bars. Insert each hand screw through the reinforcement bar and leg tube.
8. Attach the backrest tubes to the bottom of the bench. Use the 4 long hand screws to attach the tubes. Insert each hand screw through
the back rest tube and leg tube.
6.
9. Place a leg extension piece on each leg. Make sure that all 4 legs are adjusted to same height.
10. Stand the chair upright. Attach the back rest pad to the back rest tubes using the remaining 4 short screws.
11. Insert one arm rest on each side. The armrest should lean to the outside of the chair.
12. Your chair should now be complete.
9.
G2-100KHX1 G2-200KHX1 (PIC-00303)
Rev: 09/08/2020
7-a.
10.
7-b.
11.
8-a.
8-b.
12.
3
