Idiomas disponibles
Idiomas disponibles
Quick Clamping Nut
Instead of the clamping nut 10, the quick-clamp-
ing nut 11 (accessory) can be used. Grinding
tools can then be mounted without using tools.
The quick-clamping nut 11 may be used only
for grinding and cutting discs.
Use only a flawless, undamaged quick-clamp-
ing nut 11.
When screwing on, take care that the side with
printing does not point to the grinding disc. The ar-
row must point to the index mark 21.
21
11
4
4
Never loosen a tight quick-clamping nut with
pliers but use a two-pin spanner.
Insert the two-hole spanner as shown in the illus-
tration.
Lock the grinder spin-
dle with the spindle
lock button 4. Tighten
the
quick-clamping
nut by forcefully turn-
ing the grinding disc in
the clockwise direc-
tion.
A properly tightened
undamaged,
quick-
clamping nut can be
loosened
by
hand
turning the knurled
ring in the counter-
clockwise direction.
Approved Grinding Tools
All grinding tools mentioned in this operating
manual instruction can be used.
The permissible speed [rpm] or the circumferen-
tial speed [m/s] of the grinding tools used must at
least match the values given in the table.
Therefore, always observe the permissible
rotational/circumferential speed on the label of
the grinding tool.
max.
[mm]
D
d
115
D
125
b
D
115
125
d
75
b
D
Initial Operation
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
To start the machine, press the On/Off switch 2
forward.
To lock-on, press the On/Off switch 2 down at
the front until it engages.
To switch off the machine, release the On/Off
switch 2 or press the rear tip of it down.
Test run!
Check the grinding tool before use. The
grinding tool must be properly mounted and
rotate freely. Perform a test run of at least
30 seconds without load. Do not use dam-
aged, out-of-round or vibrating grinding
tools.
[mm]
b
d
rpm
[
]
6
22,2
11 000
6
22,2
11 000
–
–
11 000
–
–
11 000
30
M 14
11 000
® ®
[m/s]
80
80
80
80
45
15
