Orbegozo EP 4100 Manual De Instrucciones página 10

Idiomas disponibles

Idiomas disponibles

EP 4100
• Unwind the power cord from the base and if it is necessary assemble the appliance according to
description of parts.
USING OF THE APPLIANCE
Assembling and removing of the cone.
The cone places on motor shaft directly, until it is at the same level than filter. If you want to use
the big cone, you should place it on the small one.
1. Place the appliance on a safe and flat surface, position it such that it cannot tilt over.
2. Place the juice tank in center of upper housing (the hole of juice tank should be on motor shaft) and fit it
firmly. Place a glass or recipient under the pourer and push it down to be ready for pouring juice.
3. Then place the s.s. filter on juice tank and cone on motor shaft.
4. Connect the plug of power cord to mains 230V, 50Hz according current normative.
5. Cut the citrus fruit in half. Place the fruit on cone and go down the lever. When press the fruit, the
appliance starts to works rotating automatically. To improve the juice extraction, release pressure and
press again the fruit with lever.
Attention: Do not use the appliance for more than 2 minutes! In this case, let the appliance rest for 10
minutes.
6. The juice flows then to recipient which is below the pourer. The pulp and seeds of the fruit will keep on s.
s. filter.
7. After using the appliance, remove the plug from mains and clean the appliance as shows CLEANING
field.
The power cord can be wrap in bottom side (cord storage).
Notice:
- The big cone is for big fruits as oranges or grapefruits. The small cone is for small fruits as lemons or
limes.
- If you extract great quantity of juice you will have to clean the filter periodically to better flowing of juice.
Important:
• We recommend drinking the juice as soon as possible.
• Never save the juice in metallic recipient.
CLEANING
• Before cleaning the appliance unplug it from the mains.
• After each use you must clean the citrus juicer.
• Clean the juice tank, s. s. filter, cones and press cone cover in soapy water. Remove carefully the cone to
clean it. Never use abrasive cleaning products.
• The following parts can be cleaned in dishwasher: press cone cover, big cone, small cone, s. s. filter and
juice tank.
• Clean motor body and power cord with damp cloth and dry it immediately with dry cloth.
• Never immerse the motor body in water!
• After cleaning you can assemble the appliance to store it.
10
loading