Trust PREMIUM-LINE ZWLD-100 Manual Del Usuario página 5

5. MOUNT THE DETECTOR
A
Remove the plastic layer from the double sided-tape on the back of the detector and place it on a flat service on the
wall in a place with a risk of leakage.
B
Remove the plastic layer from the double sided-tape on the white sensor at the end of the cable and place it firmly on
the floor.
RESET DETECTOR AND ACTIVATE CONNECT MODE
Warning: This step will disconnect the detector from the Smart Bridge or the ICS-2000. To reset the detector press the
button in the hole at the side for approximately 5 sec with the included pin. The LED will flash 6x to confirm the reset.
Activate connect mode: After resetting the detector you can activate the connect mode by
pressing the button in the hole on the side for approx. 2 sec. The LED will flash fast for 1 minute to indicate the connection
mode.
DISCLAIMER
This product is used as a warning device to aid the user in detecting a water leakage. However, it remains the
responsibility of the end-user to detect and prevent water from leaking. Therefore Trust cannot be held responsible or
liable for any water damages and injuries resulting from any subsequent damages.
ZWLD-100 WATERLEAKAGE DETECTOR
EN
5