Idiomas disponibles
Idiomas disponibles
Technical data
Operating data
Water Pressure (recommended)
Water Pressure (max.)
Hot Water Temperature (recommended)
Hole Size For Faucet
Certifies this faucet complies with ASME A112.18.1 / CSA B125.1, NSF/ANSI/CAN 61-2021:
Q<1, NSF 372. The faucet also complies with water usage requirements of the California
Energy Commission and the US Department of Energy.
Installation instructions
Before you begin
For best results, Franke recommends
this faucet be installed by a licensed,
professional plumber. The installer
should familiarize themselves with how
this dispensing faucet will be installed
and function as part of a point-of-use
water dispensing arrangement before
the products are installed because there
are several installation options. Make
certain to observe all local plumbing and
building codes during the installation.
Hot water installation
options
The UNL-HO-304 Series dispenser
offers hot water only. This dispenser
is required to be used in conjunction
with a Franke heating tank unit. Use of
a Franke filtration system in addition to
the heating tank is optional, but strongly
recommended in order to prolong the life
and improve the performance of the heat
tank, as well as providing much higher
quality water as compared to un-filtered
water entering the tank.
Value
35-75 PSI
2.4-5 bar
145 PSI
10 bar
120-140°F
50-60°C
1-1/4"
32 mm
The UNL-HC-304 Series dispenser
offers hot and filtered water separately.
This dispenser must be used in
conjunction with both a Franke heating
unit and a Franke filtration system.
These models both utilize 3 tubes to
connect to the system.
– A 3/8" poly-tube for the cold water
supply into the dispending faucet.
– A 1/4" poly-tube to carry the filtered
water from the dispensing faucet to the
heating tank unit.
– An opaque high temperature silicone
tube to carry the heated water from the
heating tank back to the dispensing
faucet.
Cold water installation
options
The UNL-FW-304 Series dispenser
provides filtered drinking water as well
as the option of chilled drinking water.
This dispenser is required to be used
in conjunction with a Franke filtration
system. For chilled drinking water, a
Franke chiller tank unit is required. This
model utilizes a 3/8" poly-tube to supply
filtered water to the faucets.
5
EN
240-500 kPa
1000 kPa
