Idiomas disponibles
Idiomas disponibles
• If the refrigerant tubing is pierced, it
must be repaired only by licensed service
personnel.
• Please consult the maintenance and use
manual before cleaning the product. All
safety instructions must be followed.
• Dispose of the product in accordance with
federal or local regulations.
1.7 Hydrocarbon (HC) Warning
Your product's cooling system contains R600a.
This gas is flammable. Therefore, be careful not to
damage the cooling system or the tubing during use
or transportation. If damaged, keep the appliance
away from potential sources of ignition, which could
cause it to catch fire, and ventilate the room where
the appliance is placed.
Note
If the appliance is damaged or if you see a
gas leak, please keep away from the gas. It
may cause ice burn if it comes into contact
with the skin.
Note
The type of gas used in the product is listed
on the rating label, which is located on the
left interior wall of the refrigerator.
WARNING
Never attempt to burn the product as a
means of disposal.
1.8 For Appliances with a Water
Dispenser/Ice Machine
> The operating pressure for the cold water inlet
is 25-80 psi (1.7-5.5 bars). If the water pressure
exceeds 80 psi (5.5 bars), install a pressure limiting
valve to your water supply system.
> If the water supply pressure is lower than 25
psi (1.7 bar), you can use an auxiliary pump to
compensate for the low pressure.
> If you do not know how to check the water
pressure, please consult a professional plumber.
> If there is a risk of water jet impact during your
installation, make sure to use water jet impact
protection equipment during installation.
> Please consult a professional plumber if you are
not sure if your installation involves a water jet
impact risk.
> Do not install anything on or over the hot water
inlet.
> Take the necessary measures to prevent any risk
of the hoses freezing.
> The operating water temperature range is
between a minimum of 34°F (1 °C) and a maximum
of 100°F (38 °C).
WARNING
Never connect the product to a cold-water
supply system with a pressure higher than
80 psi (5.5 bars).
EN
7
