Mx Onda MX-PM2780 Manual De Instrucciones página 44

During the process of making the popcorn, the door of the popcorn
machine must remain closed.
To disconnect the appliance from the mains, gently pull the plug from the
socket. Never do it by pulling the cable.
Unplug the popcorn machine and wait for the bucket to cool before
proceeding to clean it.
Make sure that the cable does not hang over the edge of the table,
countertop or counter, or that it touches hot surfaces.
This device works at high temperatures, so during its use DO NOT touch
the kettle. Use the handles or handles for handling.
Disconnect the popcorn machine, whenever it is not being used, when
there is a power cut, "jump" a fuse or automatic and before proceeding with
the maintenance cleaning itself.
Do not place the popcorn machine on or near gas burners, hot plates, or
hot ovens.
The use of accessories not recommended by the appliance manufacturer
may cause fire, electric shock or bodily injury.
In case of failure, anomalies, if the popcorn machine has fallen, the plug or
other parts are damaged, or the cable is damaged, turn off the device and
do not try to repair it on your own. Contact the nearest MX ONDA Official
Technical Service.
INSERTION AND EXTRACTION OF THE POPCORN KETTLE
The kettle can be removed for easy cleaning, remember to unplug the popcorn
machine from the mains socket and wait until it is completely cold before
cleaning it.
To remove the kettle follows the following process:
1. Disconnect the power plug from the kettle, from the connector located on
the top of the inside of the main unit.
2. Gently move the kettle up, remove the lugs from the support brackets and
remove the kettle from the main unit.
To insert the kettle follows the following process:
1. Insert the kettle into the interior of the main unit and align the lugs of the
kettle with the slots of the support brackets, then slightly move the kettle
downwards.
2. Release the kettle so that it is vertical and the gears are engaged.
3. Attach the kettle power plug to the connector on top of the inside of the
main unit.
4