Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION (CONTINUED)
CAUTION
•
DO NOT operate any heater with a damaged cord or plug or after the heater malfunctions.
•
DO NOT operate any heater if it has been dropped or damaged in any manner. Disconnect power at service panel
and have heater inspected by a reputable electrician before reusing.
•
Any repairs to this fireplace should be carried out by a qualified service person.
•
Under no circumstances should this fireplace be modified. Parts having to be removed for servicing must be replaced
prior to operating this fireplace again.
•
Household use only
•
Do not use outdoors
•
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never place heater where
it may fall into a bathtub or other water container.
•
To disconnect this appliance, turn controls to the OFF position, then remove plug form outlet.
•
Only connect to properly grounded outlets.
•
This appliance, when installed, must be electrically grounded in accordance with local codes, with the current CSA
C22.1 Canadian Electrical Code or follow U.S.A Installations, follow local codes and the National Electrical Code,
ANSI/NFPA N0.70.
To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces, like
•
bed, where opening may become blocked.
•
The heaters MUST NOT be located immediately below a socket-outlet.
•
ALWAYS plug heaters directly into a wall outlet/ receptacle. NEVER use with an extension cord or
relocatable power tap (outlet/ power strip).
•
DO NOT slide insert on top of wood to avoid scratching wood surface.
•
DO NOT place any object on top of the insert or block the air intakes/ vents as this can cause the unit to overheat and
could cause a fire.
ELECTRICAL CONNECTION
•
A 15-Amp, 120-volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a
dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when
the heater is in operation. The unit comes standard with 6-ft. three-wire cord, exiting from the rear of the fireplace. DO
NOT exceed the current rating of the current tap.
GROUNDING INSTRUCTIONS
•
This heater is for use on 120-volt. The cord has a plug as shown below. See illustration or grounding instruction. An
adapter as shown at C is available for connecting three-blade grounding type plugs to two-slot receptacles. The green
grounding plug extending from the adapter must be connected to a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a three-slot grounded receptacle is available.
A
Grounding Pin
LOCATING YOUR FIREPLACE
When choosing a location for your new fireplace, ensure the general instructions are followed. Also, for best effect install
the fireplace out of direct sunlight. It is safe to set the fireplace insert close to non-combustibles.
B
Metal Screw
Cover of
Grounding
Box
3
C
Grounding Means
Adapter
