Idiomas disponibles
Idiomas disponibles
Instructions for Use
Before connecting to the mains power supply, place the tower fan onto a flat, stable
surface, allowing for sufficient distance between the tower fan and any objects that
could get damaged or caught in the rotating fan blades.
Using the 14 Inch Mini Tower Fan
STEP 1: Plug in and switch on the tower fan at the main power supply.
STEP 2: To turn on the tower fan without oscillation, turn the control dial to the right
until the desired cooling speed has been selected. There are three cooling speed
settings – speed setting '1' is the lowest cooling speed and speed setting '3' is the
highest.
STEP 3: To use the oscillation function, turn the control dial to the left until the desired
cooling speed has been selected.
STEP 4: Turn off the fan by turning the control dial to either of the two positions
marked 'OFF'
CAUTION: DO NOT COVER THE TOWER FAN
CLEANING / MAINTENANCE INSTRUCTIONS:
During Season Care:
•
Before cleaning, be sure to turn off and unplug the fan.
•
Keep fan clean. Carefully wipe the unit with a soft, damp cloth.
•
DO NOT immerse the fan in water and never allow water to drip into the motor
housing. Please be very careful near the motor.
•
Never use gasoline, benzene or thinner. This will damage the surface of the fan.
•
After cleaning, be sure to dry the fan completely with a cloth or towel.
After Season Care:
•
Before putting the fan in storage, clean thoroughly, cover with a plastic bag and
store it in a cool and dry place. We recommend using the original or a properly
sized box.
Maintenance:
•
Do not attempt to repair or adjust any electrical or mechanical functions of this
unit. Doing so will void the warranty. Return to Optimus for service.
•
If the power cord is damaged, the unit must be discarded to avoid a hazard.
•
This product must be disposed of properly according to local authority. By
recycling, you help save the environment.
USER SERVICING INSTRUCTIONS:
This product employs overload protection (fuse). A blown fuse indicates an overload
or short-circuit situation. If the fuse blows, unplug the product from the outlet.
Replace the fuse by following the servicing instructions below (follow product
marking for proper fuse rating). If the replacement fuse also blows, a short-circuit
may be present and the product should be discarded or returned to an authorized
service facility for examination and/or repair.
•
Grasp plug and remove it from the receptacle or
other outlet device. Do not unplug by pulling on
cord.
•
Select a suitable tool such as a small flat
screwdriver.
•
Open the fuse access cover by sliding or prying it
open.
•
Carefully remove the fuse by prying it out from one
end or by turning the fuse holder over.
•
Risk of fire. Replace fuse only with 2.5 Amp, 125
Volt fuse. Gently press the new fuse into the slot at
both ends. Do not press on the glass tube.
•
Close the access cover until it is flush with the plug face.
•
Do not replace the plug. It contains safety devices (fuse, AFCI, LCDI) that should
not be removed. Discard the product if the plug is damaged.
Tips:
•
Do not overexert when replacing the fuse or damage may occur.
•
If it's hard to close the access cover, make sure the fuse is fully inserted.
