Idiomas disponibles
Idiomas disponibles
1
INSTALLATION AND FRAMING INSTRUCTIONS
The alcove opening dimensions should be at least 1/8" (3mm) larger than dimensions shown on
spec page for the model being installed.
For the best fit, the opening measurements should be verified against the actual
shower base received.
1a. Ensure that the floor and stud walls are square and plumb on a level floor as shown in Figure A.
Provide a 7" x 7" (178 x 178 mm) opening in the floor for the drain and refer to the product rough-in
on the specification page for actual drain location.
NOTE: Maximum weight support of 300lbs without mortar. Mortar is required during installation for user
weights exceeding 300lbs.
2
INSTALLATION OF DRAIN ASSEMBLY
2a. All of the shower bases require purchasing a round drain for use with a standard 2" (51 mm) plastic
schedule 40 waste pipe. Figure B shows the typical drain assembly. Before installing drain into the
shower base, remove strainer. (Ref. Figure B) This will be installed after shower base is in its final position.
Cut the waste pipe height so that the drain body will fit snug in the shower base. Apply silicone sealant
between the drain body and shower base.
NOTE: Drain not included and must be purchased separately.
90°
2" (51 mm)
C/L
PVC Waste Pipe
(See Product Rough-In on specification page for Drain Location)
FIGURE A
DRAIN ASSEMBLY
Rubber
Caulking
Gasket
Drain
Body
Silicone
Sealant
Rubber
Gasket
FIGURE B
90°
Opening 6" x 6"
(152 x152 mm)
Strainer
Shower
Base
Fiber
Gasket
Locking
Nut
