Worx WX641 Manual De Instrucciones página 11

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.The sander is not
to be used for plastering。
ASSEMBLY AND OPERATION
Action
ASSEMBLY
Fitting &Removing the
Sanding Paper
Paper Punch (Optional)
Attaching the Dust Box
Caution: To prevent
the possibility of
sanding dust or foreign body
being thrown into your face
or eyes, never attempt to use
your sander without the dust
box properly installed.
Emptying the Dust Box
-For more efficient
operation, empty dusts box
every 5-10mins.
Using the Dust Extraction
Adapter
OPERATION
Plugging in the power
Switching On/Off
Variable speed control (only
for WX642 WX642.1)
WORKING HINTS FOR YOUR
FINISHING SANDER
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds. Always use
sand paper that is suitable for the material you want
Finishing Sander
Figure
See Fig. A1, A2
See Fig. B
See Fig. C
See Fig. D1, D2
See Fig. E, F
See Fig. G
See Fig. H
See Fig. I
to sand.
Always ensure the work-piece is firmly held or clamped
to prevent movement.
Any movement of the material may affect the quality of
the sanding finish.
Start your sander before sanding and turn it off only
after you stop sanding. For the best results, sand wood
in the direction of the grain.
Do not start sanding without having the sandpaper
fitted.
Do not allow the sandpaper to wear away it will damage
the base-plate. The guarantee does not cover base-
plate wear and tear.
Use coarse grit paper to sand rough surfaces, medium
grit for smooth surfaces and fine grit for the final
surfaces. If necessary, first make a test run on scrap
material.
Use only good quality sandpaper.
The sandpaper controls the sanding efficiency, not
the amount of force you apply to the tool. Excessive
force will reduce the sanding efficiency and cause
motor overload. Replacing the sandpaper regularly will
maintain optimum sanding efficiency.
MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal. If the supply cord is
damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to
avoid a hazard.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
11
EN