Placing The Device In Operation; Detaching/Attaching The Control Panel; Switching On/Off; Adjusting The Volume - Blaupunkt Buenos Aires 200 Instrucciones De Manejo

Placing the device in operation

Placing the device in operation
Detaching/attaching the control
panel
The device is equipped with a detachable control
panel (fl ip-release panel) as a way of protecting
your equipment against theft. Always take the
control panel with you when leaving the vehicle.
The device is worthless to a thief without this con-
trol panel.
Caution
Damage to the control panel
Never drop the control panel.
Do not expose the control panel to direct sunlight
or another heat source.
Avoid direct skin contact with the control panel's
electrical contacts.
Removing the control panel
u button 1 to unlock the control
Press the
panel.
u
Grasp the control panel at the left side and
fi rst pull it straight out of the bracket and
then to the left.
Attaching the control panel
u
Push the control panel into the bracket at the
right edge of the device.
u
Push the control panel carefully into the left
bracket until it clicks into place.

Switching on/off

u
With the vehicle ignition switched on, briefl y
press the On/Off button 4 to switch on the
device.
- or -
Press the On/Off button 4 for approx.
u
2 seconds to switch off the device.
The device remembers the audio source played
last for the next switch-on. Any CD already insert-
ed in the device remains there.
6
Notes:
• If the vehicle ignition is switched off, the
device cannot be switched on with the
On/Off button 4 .
• The device is switched off and on again
with the vehicle ignition if it is connected
with the ignition (see the installation in-
structions).

Adjusting the volume

You can adjust the volume in increments from
0 (off) to 66 (maximum).
Turn the On/Off button 4 to change the
u
volume.
Note:
If a telephone or navigation system is con-
nected with the device as described in the
installation instructions, the device is muted
with every telephone call or a navigation
announcement. The display then shows
"PHONE".

"NO SRC" mode (muted)

Instead of an audio source, you can select the
"NO SRC" mode ("No Source": no audio source).
In "NO SRC" mode, no audio source is selected
and the device is muted.
Certain user settings can be performed only in the
"NO SRC" mode.
Changing to "NO SRC" mode
Press the On/Off button 4 repeatedly until
u
"NO SRC" appears.