Assembly Sequence - AERMEC Novatherm DMH 220 Manual De Uso, Instalación Y Mantenimiento

DMH - DMH_C - DMV
MACHINE POSITIONING (RECESSED
VERSION)
• We recommend positioning the
unit at about 15-20 cm from the
ground
•
Hydraulic and drainage connections
are located near the gap of the
unit, which allows for rear, side or
bottom connections.
• If the outer casing is supplied, it
must be walled up beforehand in
the recess, leaving the holes to
let the pipes and electrical cables
through on the required side. If
necessary, drill a hole in the wall
to discharge the overall dimensions
of the bush-holder inserts used to
lock the front grid (fig. 1)

ASSEMBLY SEQUENCE

Grid locking bush
895
897
Outer casing
Electrical connections
Connessioni elettriche
Condensate drain Scarico condensa
Connessioni Idrauliche Hydraulic connections
IMPORTANT:
• THE INSTALLATION MUST BE
C A R R I E D O U T I N S I D E T H E
BUILDINGS. PROVIDE FOR ALL
T H E N E C E S S A R Y H O L E S T O
ENSURE THE CHILLED WATER
P I P E S, WAT E R C O N D E N SAT E
D R A I N I N G S Y S T E M
ELECTRIC CABLES CAN PASS.
1. Apply the angular fastening ele-
ment supplied with the outer cas-
ing on the side of the machine,
the fixing angle supplied with the
unit.
2. Insert the unit in the outer cas-
ing, locking it at the back via the
angular element by using the
self-drilling screws supplied (fig.
2)
3. E n s u r e a l l t h e e l e c t r i c a l
connections pass inside the
machine from the holes under
the control panel and go ahead
with the internal connections
4. R e c o n n e c t t h e e l e c t r i c a l
connectors and lock the door of
the electrical control board to its
Grid locking bush
fig. 1
• L EAV E AT L EA ST 150 C M AT
T H E F RO N T TO E N S U R E T H E
DEHUMIDIFIED AIR CAN FREELY
CIRCULATE.
A N D
5. Centre the covering grid on the
250
252
EN
panel
front bushes with the slotted
holes on the grid itself. Lower the
grid until it is fully engaged on
the bushes and bring the bottom
close to the flange of the outer
casing, on which it will be locked
due to the action of a small
magnet (fig.3).
Fastening angular element
Fan
Compressor
fig. 2
Bush slot
Magnet
fig. 3
25