Stihl FS 40 Manual De Instrucciones página 27

Hold the starter grip with your right
N
hand.
Models without Easy2Start
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
Models with Easy2Start
Pull the starter grip steadily.
N
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking until the engine
N
runs.
FS 40, FS 40 C, FS 50, FS 50 C
As soon as the engine runs
Press down the throttle trigger
N
lockout lever and open the throttle –
the choke lever moves to the run
position F . After a cold start, warm
up the engine by opening the
throttle several times.
Make sure the carburetor is correctly
adjusted. The cutting attachment must
not rotate when the engine is idling.
Your machine is now ready for
operation.
Stopping the engine
Move the momentary stop switch in
N
the direction of 0 – the engine
stops – release the momentary stop
switch – t springs back to the run
position.
Other hints on starting
Engine stalls in cold start position g or
under acceleration
Move the choke lever to < and
N
continue cranking until the engine
runs.
Engine does not start in warm start
position <
Move the choke lever to g and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Fuel tank run until dry
After refueling, press the fuel pump
N
bulb at least five times – even if the
bulb is filled with fuel.
Set the choke lever to suit the
N
engine temperature.
Now start the engine.
N
English
25