Maintenance; Troubleshooting - Belkin F5U302ea Manual Del Usuario

1
2
3
4
5
6
5427ea_F5U302ea_man.indb 20

Maintenance

The following sections provide maintenance information and
troubleshooting advice.

Troubleshooting

1. How do I delete a computer that has been previously
set up to work with my Hub?
The Wireless USB Hub maintains a list of computers to
which it can connect securely. To delete one computer
from the list, plug the included USB cable (or one like it)
into the Hub and computer, as you did during the initial
setup. After a few seconds, a new "Administration" tab
will appear in the Wireless USB Control Center. Select
the "Administration tab" and view a list of the computers
that have been set up to communicate with this Hub.
Follow the instructions on the screen to delete one or
more computers from this list.
2. I have gone through the cable-association procedure,
but still cannot connect to the Hub.
Check that the power supply is connected and that the
blue LED on the Hub is lit.
If you are sure there is power to the Hub, open the
Wireless USB Control Center. On the "Devices" tab,
your Hub should be one of the devices listed. If it is not,
perform the cable-association procedure again.
If you see your device listed, make sure that it says
"Connected" and you see green bars indicating that it
is connected. If the software says "Not Available",
move your Hub closer to the computer to see if that
fixes the problem.
EN-20
12/19/2007 3:40:34 PM