Idiomas disponibles
Idiomas disponibles
•
Remove any protective fi lms and adhesive labels from the
stainless steel soleplate before using the appliance.
•
Completely unwind the line cord.
Ironing without steam (steam jet regulator on „Ø")
1. Place the iron on its stand (9).
2. Turn the steam regulator (4) to „Ø".
3. Always set the temperature control (1) to „min" before
connecting the appliance to a power point, or before discon-
necting it.
4. Sort out the garments according to their ironing tempera-
tures. Start with the lower temperatures. It is set with the
thermostat (1):
Synthetics, silk
Wool
Cotton, linen
max
5. Electrical connection
•
Make sure that the iron voltage (see name plate) and
the line voltage match.
•
Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
6. The control lamp (2) lights up. As soon as it shuts off, the
set temperature is reached. Now you can start to iron.
7. Always pull the plug out of the socket after using the iron.
Steam Ironing ( )
For this a high temperature is needed (cotton, linen).
The quantity of steam can be regulated using the steam quantity
regulator (4).
no steam „Ø
Extra steam can be added with the steam jet function „ " (3).
WARNING: The steam is hot. Danger of scalding!
When ironing at low temperatures, make sure that you reduce
the quantity of steam or iron without steam. If the temperature
is too low water may leak from the soleplate. The appliance
features an „anti-leakage function" which deactivates the
steam mode if the temperature chosen is insuffi cient for steam
operation.
Refi lling the water tank
•
Always disconnect the mains plug before refi lling water.
•
Set the steam control (4) to „Ø" (no steam). Open the lid
of the refi ll inlet (6) and carefully pour in the water. Do not
exceed the maximum line as marked on the water reservoir.
Spray Function ( )
In order to moisten a section to be ironed press the spray button
(5).
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
05-DB 766 CB 25
Self-Cleaning (Self-Clean)
1. Half fi ll the water tank with water.
2. Heat the machine up to its maximum temperature. After the
3. Now hold the iron horizontally over a sink. Keep the
low temperature
medium temperature
4. Place the machine back on its stand and heat it up again. To
high temperature
maximum temperature
•
•
•
•
•
Model:.......................................................................... DB 766 CB
Power supply:............................................................230 V, 50 Hz
Power consumption:..........................................................2500 W
" Large steam volume
Protection class:........................................................................... Ι
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!
NOTE:
To avoid excess water leaking from the soleplate do not
operate the steam burst for more than 5 seconds without
interruption.
control lamp goes off remove the machine from the mains
supply.
„self clean" button pressed down. Now rock the device
backwards and forwards until the tank is empty. When you
release the „self clean" button, it returns automatically.
clean the base now iron over a clean cotton cloth.
Cleaning and Storage
Always remove the mains lead before cleaning!
Clean the casing with a slightly damp cloth.
Clean the iron with a slightly humid cloth.
Always return the steam regulator to the „Ø" position after
use and empty the water tank in order to prevent any leaks.
The device must never be immersed in water!
Technical Data
25
30.11.2006, 15:07:55 Uhr
