M.-Nr. 11313351
Risk of cuts during service and maintenance work
WARNING
Components may have sharp edges.
There is a risk of cuts during service and maintenance work.
A
Protective gloves should be worn.
Danger of injury due to excess physical strain
WARNING
Danger of injury due to excess physical strain.
Spinal injuries.
A
The relation of the weight of the machines to the physical strength of the technician must be taken into account.
For machine weight details, see the operating instructions.
Preparing the plinth
A
Use 2 screws (6 x 12) to attach each of the clamping plates to the rear of the plinth, see Fig. 1.
The arrow embossed on the top of the plinth points to the front, see Fig. 1.
A
Level the plinth on the floor.
A
Mark the hole positions.
A
Drill holes measuring 12 mm in diameter in the marked positions, to a depth of approximately 65 mm.
A
Insert plugs (5) into the holes, see Fig. 2.
A
Line the plinth up with the underlay supplied (4), see Fig. 2.
A
Fasten the plinth to the floor with the hexagonal-head wood screws (1), 8.4 washers (2) and 15 x 44 x 3 washers (3),
see Fig. 2.
Fitting a washing machine to the plinth
A
Fit the tensioning strips on the plinth and fasten them in the appropriate holes (1), see Fig. 3.
A
Secure each tensioning strip to the plinth with 1 M6 x 30 bolt (1), 2 galvanised B6.4 washers (2) and 1 M6 nut (3).
Do not tighten the nuts yet, see Fig. 4.
A
Unscrew the washing machine feet by at least 5 mm.
A
Set the washing machine down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the washing machine on the plinth.
A
Use the tensioning strips to fix the washing machine to the front feet, see Fig. 4.
A
Fit another M6 nut (4) to each of the feet to counter the first nut, see Fig. 4.
A
Screw 1 M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 5.
Fitting a tumble dryer to the plinth
A
Unscrew the tumble dryer feet by at least 5 mm.
A
Set the tumble dryer down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the tumble dryer on the plinth.
A
Screw 1 M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 6.
Fitting the plinth panels
A
Use 4 M4 x 25 screws to attach each of the 2 side panels, see Fig. 7.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
8 von 50
12.05.2021
