Idiomas disponibles
Idiomas disponibles
away from your body in a
downward position, and apply a
drop of BabylissPro lubricating oil
on the front and sides of the cutter
blade. Wipe off excess oil with a
soft, dry cloth.
Do not pull, twist, or wrap the
supply cord around the appliance.
HOW TO USE COMB ATTACH-
MENTS
To use the comb attachments,
turn the clipper to "0" position.
Slide the comb attachment onto
the top of the clipper blade, and
then pull down and over the back
of the blade (Fig. 2). To remove,
pull up on the back of the comb
attachment and then pull away
from the blade.
Fig. 2
REPLACEMENT (REMOVAL) OF
BLADE SET
Step 1. Unplug the unit and adjust
the taper (see illustration A).
Step 2. Remove the screws and the
fixed blade. Save the screws.
Step 3. Lift off the small moving
blade and replace it with the new
one on the plastic oscillator (see
illustration B).
Step 4. Replace the fixed blade
using the screws and lightly
tighten them. Adjust the
teeth as shown in illustration C, to
a gap of 1 mm to 1.5 mm, and the
small, moving blade as centered
and parallel as possible to the
fixed blade's teeth.
A.
Taper
IMPORTANT NOTE:
The top edge of the fixed blade
must be a minimum of 1mm hight
than the top edge of the moving
blade, as centered as possible. This
is important so that the moving
blade does not come in contact
with the skin.
Be sure to add a few drops of
BaBylissPro lubricating oil to the
blades before running.
Don't forget to tighten the screws
after the blades have been
aligned.
Fixe Blade
C.
C.
Small
Moving
Blade
ADJUSTABLE TAPER LEVER
The taper lever is positioned at
your thumb. You can hold the
clipper in your hand and adjust
the lever at the same time – while
7
B.
Plastic Oscillator
Small
Moving
Blade
1 to 1.5mm
