Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Swash Installation, External Bidet Filter Installation
11. Plug the Power Cord into an Electrical Outlet
a. If the Power Indicator is not illuminated press any button on
the control panel.
NOTE: Make sure to only use a grounded GFCI (ground fault circuit
interrupter) electrical outlet. In the case of a short circuit, a grounded
GFCI outlet may help prevent electric shock or injury.
12. Press the "REAR WASH" button on the control arm to fill the
water tank. The bidet will beep continuously while it fills and
then issue one long beep when the water tank is full. Wait 3-5
minutes for the water to heat, and then the Swash will be ready
to use.
13. Follow instructions on Page 16 for using the Swash.
External Bidet Filter Installation
NOTE: Customers with hard water, well water, and softened water can extend the life of their
bidet seat by purchasing and installing an external inline water filter to be used with the Swash.
The bidet filter should be changed every six months, and can be purchased online at brondell.com.
1. Turn Off Water Supply Valve and Flush Toilet.
a. Turn water valve off to stop the flow of water.
b. Flush toilet and hold down handle to completely empty tank.
2. Disconnect the Bidet Hose from the T-Valve
3. Connect the female end of the Swash Filter to the open T-Valve connection.
4. Connect the Bidet Hose to the male end of the Swash Filter.
5. Turn the toilet water supply valve back on.
Step 2
FLOW
Step 3
FLOW
Step 4
13
