Idiomas disponibles
Idiomas disponibles
9. STORAGE INSTRUCTIONS
1. Charge battery to full capacity before storage.
2. Store this unit at temperatures between - 5°F- + 140°F ( - 20°C- + 60°C).
3. Never completely discharge the battery.
4. Charge after each use.
5. Charge at least once every month, if not in frequent use, to prevent
over-discharge.
10. TROUBLESHOOTING
PROBLEM
The jump starter's display will
not turn on.
The display backlight is
flashing.
The jump starter will not
recharge.
The jump starter turns on, but
won't jump start my vehicle.
The green LED on the smart
cable does not light when its
button is pressed.
Smart Cable LED Behavior
Green LED lit solid
Green LED flashes three times Reverse charging protection
Red LED flashes once
Red LED flashes twice
Red LED flashes four times
Red LED flashes five times
Red LED lit solid
Make sure the unit is charged.
Connect to AC power, using the provided
wall charger, to reset.
Make sure the ON/OFF switch is set to
the ON position.
The unit is too hot or cold. The light will stop
flashing when the condition is removed.
The battery is very low. Recharge the battery.
Make sure to use only the provided wall
charger.
Make sure you have pressed the smart
cable's
button.
Verify the charge level of the jump starter is
at least 40%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
the vehicle still does not start, consult a
qualified service technician.
Check connections.
If an LED is flashing, refer to the table
below. When the condition is corrected,
the smart cable will automatically reset.
Ready to jump start
Reverse polarity protection
Short circuit protection
Low voltage protection
High temperature protection
OK to press
• 10 •
SOLUTION
button to jump start
