Idiomas disponibles
Idiomas disponibles
SP6820-2 Workshop 2018.qxp_WS1200VA0 WS1600VA0 7/20/18 1:56 PM Page 11
filter
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
Removal and Installation
of the Qwik lock™ filter
filter Removal:
1. Hold the Filter Tabs of the Qwik
Lock™ Filter in each hand.
2. With one thumb on the Qwik Lock™
Stud, which protrudes through
the integrated Filter Plate, lift up on the
Filter Tabs while pushing down on
the Stud.
3. This action will cause the Filter
to release from the Filter Cage.
Slide Filter off Cage.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the Filter before using the Vac for dry
material pick-up.
filter Installation:
1. Carefully slide the Qwik Lock™ Filter
over the Filter Cage and press down
on the outside edge of the Filter until
the Rubber Gasket on the bottom of
the Filter seats securely around the
base of the Filter Cage and against
the Powerhead Assembly.
mAINTeNANce
2. Align the small Center Hole in the top
of the Filter over the Qwik Lock™
Stud on the Filter Cage. Press firmly
on top of the Filter near the Stud to
allow the Filter to snap over the Ball
on the end of the Stud. The Filter is
now attached.
NoTe: Failure to properly seat the
Bottom Gasket could result in debris
bypassing the Filter.
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
Integrated Filter Plate
with Center Hole
Powerhead
Assembly
Filter Cleaning
Your Filter should be cleaned often to
maintain peak Vac performance.
11
PUSH
DOWN
PULL
UP
Filter
Tabs (2)
PULL
UP
Rubber
Gasket at
Bottom of
Filter
Qwik
Lock™
Stud
Filter
Cage
Float
