Idiomas disponibles
Idiomas disponibles
Fig. 3
Charging
red
Fully
Charged
green
3. The battery indicator LEDs will illuminate one by one
during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
4. The 24VCHRG-QC Quick Charger (sold separately) and
the 24VCHRG-DPC Dual Port Charger (sold separately)
are also equipped with additional charging indicating
lights which will indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When removing the batteries
from the charger, be sure to unplug the charger from the outlet
first, then remove the batteries from the charger.
m
WARNING!
This charger does not automatically turn
off when the batteries are fully charged. Please take care not
to leave the batteries in the charger. Switch off or unplug the
charger at the mains when charging is complete.
5. Timely recharging of the batteries will help prolong the
batteries' life. You must recharge the battery packs when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery packs to become
fully discharged as this will cause irreversible damage to the
batteries.
6. When charging is complete, remove the batteries from the
charger by pulling the push lock button and sliding the
batteries backward to unlock it from the charger.
Charging a Hot or Cold Battery Pack
The green indicator lights on the charger base indicates that
the battery packs' temperatures are outside the charging
range. Once the packs are within the acceptable range,
normal charging will take place and the red light will be
continuous. Hot or cold battery packs may take longer to
charge.
Assembly
Battery pack
m
complete. Failure to comply could result in accidental starting
and severe personal injury.
Always wear gloves during assembly.
Connecting the Handle Bars
24VCHRG-DPC
dual port charger
(Sold separately)
Thatch Collection Bag Assembly
m
the thatch collection bag attached. This could pose a danger
of flying debris.
m
cutting device must have stopped rotating before you attach or
empty the thatch collection bag.
11
WARNING!
Do not insert the batteries until assembly is
1. Fit the upper handle frame on the lower handle bars,
and secure with 2 sets of handle knob and bolt (Fig. 4).
Fig. 4
Handle knob
Bolt
R
2. Clip the cable clips on the handle, and Insert the cable in
the cable clips.
WARNING!
Do not attempt to use the product without
WARNING!
The product must be switched off and the
1. Lift the ejector flap, and hang the thatch collection bag to
the mounting hooks (Fig. 5).
Upper handle
frame
Lower handle
bars
