Idiomas disponibles
Idiomas disponibles
GB
TRANSPORT - MANUTENTION - UNPACKING
The machine must be transported as shown in the figures on the outside of the packing.
Keep all packing (plastic bags, polystyrene foam, nails, screws, metal or plastic straps, etc.) out of reach of
children and dispose of suitably, as they are potential sources of danger and pollution.
INSTALLATION
Unpack the machine and check that it is intact.
Open the doors using the relative key and remove the screws fixing the machine to the pallet. Position the mangle
adequately lighted room with an ambient temperature included from +10°C and +40°C. Place the machine on a
flat surface (minimum capacity 500 kg/m²) using the adjustable feet to be found on the bottom of the side panels
to ensure that it is stable and level.
For a correct use and operation, as well as for an easy maintenance, leave a free space around the mangle as
shown in figure n. 01
ELECTRICAL CONNECTION
Electrical connections must be carried out by fully qualified electricians.
Check that the supply voltage corresponds to that indicated on the rating plate, which is situated on the rear of the
machine to the right.
To ensure safe connection to the mains supply use a cable as specified in the enclosed wiring diagram and an
automatic cut-out protective device (differential magnetothermal switch Idn = 0.03 A). The differential
magnetothermal switch must have characteristics of section and insulation complying with Europeans norms EN
60947-2 e EN 60947-3 and must be adequated to the machine absorption (see plate data). This device and the
connecting cable are the responsibility of the user. Earth the ironer through the relative terminal in the electric
panel. The earthing system must comply with legal requirements. The manufacturer cannot be held responsible
should this accident-prevention regulation not be observed.
To ensure that the roll turns clockwise currently
(this operation is not necessary for models fitted with frequency controller: ..../25F, 1400/25 AV and
1400/25AVL).
In the event of incorrect connection, upon pressing the foot pedal control any excessive reverse rotation activates
a microswitch (pos. 27), thus preventing any mechanical displacement. To neutralize the microswitch, turn the
handwheel (see fig. 3) placed under the ironing plate motor clockwise and invert two phases in the supply
terminals.
Failure to observe these instructions may put the mechanical parts out of phase.
Disconnect the machine from the power supply before carrying out this
operation.
INTENDED USE
The IPSO range of roller ironers has been designed for ironing flat linen. Any other use is to be considered
incorrect and therefore unreasonable. The manufacturer cannot be held liable for any damage to things or injury to
persons caused by improper, incorrect or unreasonable use.
THE MANUFACTURER CANNOT BE HELD LIABLE SHOULD THE IRONER BE TAMPERED WITH OR
MODIFIED BY UNAUTHORISED PERSONS.
OPERATION
1.
Push the switch START (I) to activate the control circuit. The exhaust fan is automatically activated on models
fitted with this option.
2.
Adjust the temperature using the rotor on control panel. The yellow warning light will remain on for a few
minutes until the set temperature is reached.
3.
Set the ironing speed using + and - buttons (only for models ..../25F, 1400/25 AV and 1400/25 AVL).
4.
With the help of the feed-in wooden table, place the item to be ironed on the roller.
5.
Press the foot pedal control, to be found along the whole length of the machine, in order to activate the roller
rotation and start work.
6.
At the end of the ironing session, push the red switch STOP (0). The ironer remains idle.
, hold down for an instant the manual control button K2.
15/34
