Idiomas disponibles
Idiomas disponibles
I
NSTALLING THE
1. Locate the Voyager WiSight technology plate on your RV shown below.
2. Remove 4 screws holding plate in.
3. Underneath, you will see the standard connector shown at the bottom of the page.
4. Connect the camera connector to the connector underneath the plate as shown at
the bottom of the page.
5. Install the camera with the 4 screws that held the plate in.
6. Camera should be adjusted for optimum view before these screws are fully tightened.
Standard Connector
C
AMERA
Arrow Locking Location
12V DC
Waterproof Camera Connector
Cable Connector
End View
Link
No connection
No connection
Ground
LED Assisted
Illumination
EN-01
Antenna Vertical
Microphone
