Idiomas disponibles
Idiomas disponibles
Trouble
Red Charger light flashes or does not
light up
Unit will not turn on
Unit does not run when turned on
Running time is too short
Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
Please contact your dealer in order to dispose of the product or its parts in compliance with national laws.
Manufacturer:
YAMABIKO CORPORATION
1-7-2 Suehirocho, Ohme, Tokyo 198-8760 JAPAN
Authorized Representative in Europe:
CERTIFICATION EXPERTS B.V.
Amerlandseweg 7, 3621 ZC Breukelen, The Netherlands
Storage
Do not store in an enclosure where combustible fumes may accumulate.
You could cause a fire.
When storing the product for long periods of time, ensure that the following preparations for storage are carried out.
Motor unit
1.
Turn power to unit off.
2.
Remove battery from power head.
3.
Remove accumulation of dirt and debris from exterior of unit.
4.
Tighten all the screws and nuts.
5.
Cover the battery compartment of power head, the battery, and the battery charger.
6.
Store unit in a dry, dust-free place, out of the reach of children.
Battery
1. Remove battery from power head.
2. Store in a dry, dust-free place, out of the reach of children.
3. Store in temperatures between -20°C and 60°C (140°F).
4. If the battery is stored for longer than one year, charge it to approximately 40 - 60% capacity.
Battery charger
1. Remove battery from battery charger.
2. Disconnect battery charger from power supply.
3. Store in a dry, dust-free place, out of the reach of children.
Cause
1.
Plug not connected to power outlet
2.
Battery pack not installed properly
3.
Obstructed connection
4.
Fault in the charger
5.
Fault in the battery pack
1.
Battery pack not installed properly
1.
Battery pack discharged
2.
Battery pack outside acceptable
temperature range
1.
Battery pack outside acceptable
temperature range
2.
Unit electronics too hot
3.
Battery pack discharged
WARNING
15
Maintenance and care
1.
Plug in the charger
2.
Check the battery pack installation
3.
Reinstall battery pack again after re-
moving obstructions from connec-
tion.
4.
Consult your dealer
5.
Consult your dealer
1.
Check the battery pack installation
1.
Charge the battery pack
2.
Remove the battery pack and allow
to cool
1.
Remove the battery pack and allow
to cool
2.
Turn unit off and allow to cool
3.
Charge the battery pack
Remedy
