Idiomas disponibles
Idiomas disponibles
Before you start
Loop handle assembly
Battery Installation
The attachment will operate when the battery is installed, the power indicator LED is lit, and the trigger and trigger
lockout are engaged. Make sure the unit is properly positioned to prevent loss of control and possible serious injury.
Keep movable parts of the attachment off the ground and away from objects that could become entangled or thrown.
Remove the battery when leave the unit.
4.
Carefully fit attachment drive shaft assembly into coupler (B)
to decal assembly line (C), making sure that the inner lower
drive shaft engages into the square upper drive shaft socket.
NOTE
Lower bearing housing and head assembly must be in line with
the motor unit.
5.
Rotate locator pin (A) 1/4 turn clockwise to engage lower
shaft hole. Insure locator pin is fully engaged by twisting low-
er drive shaft. Locator pin should snap flush in coupler. Full
engagement will prevent further shaft rotation.
6.
Secure lower shaft assembly to coupler by tightening clamp-
ing knob (D).
7.
To disassemble, reverse assembly instructions.
Position handle in comfortable operating position and tighten
Bolts.
Install the handle between the marks (A).
WARNING
1.
Make sure power to unit is turned off.
2.
Align ridges (A) on battery pack with grooves in power head.
Slide battery pack into power head.
3.
Assure the battery pack latch (B) snaps into place and bat-
A B
tery pack is secure before beginning operation.
C
4.
To remove battery, depress battery pack latch release (C)
slide battery pack out of power head.
Battery pack latch is in the complete position when battery
pack latch is correctly engaged.
Before using the unit, make sure that battery is set correctly
with battery pack latch in the complete position (D).
10
CAUTION
NOTE
IMPORTANT
