Idiomas disponibles
Idiomas disponibles
FUNCTION
n.Dip
1
2
Step-by-step input
1
and radio channel
2
mode
1
2
Ch1
1
2
3
4
3
4
Jolly input mode
3
4
3
4
5
Pre-flashing light
6
Re-closure
Reclosing after the
7
photoelectric cells
8
Fototest
9
Slowdown
10
Flashing Light
Note: the standard initial configuration is shown in part 8 of fig. 1
OFF ON
DESCRIPTION
Open – Stop – Close
Open – Close
Open
Condominium function
Open – Close
(Cut out of opening control)
Safety edge during opening
Close button
Photocell 2
Pedestrian opening
Cut out
Connected
Cut out
Connected
Cut out
Connected
Cut out
Connected
Cut out
Connected
Flashing
Steady
During opening, upon pressing the P/P button the gate stops, pressing it again the gate closes.
During closing, upon pressing the P/P button the gate stops, pressing it again the gate opens.
During opening, upon pressing the P/P button the gate stops for a few instants and then closes.
During closing, upon pressing the P/P button the gate stops for a few instants and then opens.
During opening, upon pressing the P/P button there is no effect. When the gate is open, pressing the P/P
button renews the pause time. During closing, upon pressing the P/P button the gate stops for a few
istants and then opens.
During opening, pressing the P/Pbutton has no effect. During the pause, upon pressing the
P/Pbutton thegate closes. During closing, upon pressing the P/Pbutton the gate stops for a few
istants and then opens.
"Safety edge in opening" activation reverses the direction (closes) for a few seconds. After "safety edge in opening"
activation, the control unit stops and reclosing is cancelled. Use a N.C. Contact. If the system needs a safety edge
in closing, use the photocell 1 input.
The wild input becomes a CLOSE button. Use a N.O. contact.
CAUTION! With this configuration the P/P button becomes the OPEN button, the radio ch1 (optional)
maintains the P/P function.
During both opening and closing, activation of this photocell stops the gate until it is reset. The next
movement is always in the opening direction. Use a N.C. contact
The gate opens partially for a programmable time (see "pedestrian opening programming" page 37).
Use a N.O. contact
The flashing light is powered at the same time as the motor.
The flashing light is powered 5 seconds before any movement.
After one complete opening, the control unit only closes again with a manual control.
After one complete opening, the control unit closes automatically after the programmed pause
Function bypassed
The activation of the photoelectric cell reduces the pause time from whatever its value previously was to 2
seconds.
Function cut out. Output 9-8 with gate status indicator light operation.
Connect the power supply of the transmitter/s to the output 9-8. See "foto-test" paragraph on page 37.
It is always possible to parallel a 24V open gate indicator light.
There is no slowdown in the last part of travel.
With the slowdown function connected, the motor halves its speed towards the end of every gate
Output 7 - 8 flashes during motor movement.
Output 7 - 8 remains permanently lit during motor movement.
NOTES
