Zanussi ZWI 71000 WA Manual De Instrucciones página 21

35 Ø 12,5-14 depth
16-22
C
• a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height of the ad-
jacent furniture's base.
• b) Hinges
To mount the hinges it is necessary to drill two holes
(dia. 35 mm, depth 12.5-14 mm depending on the
depth of door furniture) on the inner side of the door.
The distance between the holes hobs fixing centres
must be 416 mm.
The distance (B) from upper edge of the door to the
centre of the hole depends on the adjacent furniture's
dimensions.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws
for wood (2-Fig. B) supplied with the appliance.
• c) Mounting the door
Fix the hinges (1) to the machine by means of the M
5x15 screws (3-Fig. B). The hinges can be adjusted to
compensate for possible uneven thickness of the door.
To align the door perfectly it is necessary to loosen the
screw (3-Fig. B), adjust the door and tighten the screw
again.
www.zanussi.com
B
416
22±1,5
595-598
C
D
Caution! Do not remove the screw 8 !
d) Counter-magnet (6)
The appliance is prearranged for a magnetic closure of
the door.
To enable a correct operation of this device, it is neces-
sary to screw the counter-magnet (6) (steel disk + rub-
ber ring) into the inner side of the door. Its position
must correspond to the magnet (4) on the appliance
(see picture D).
4 5
E
Caution! Do not remove the screw 8 !
4
6
8
6
1
7
3
2
8
21