Isometric View - WIKA CTD9100-ZERO Manual De Instrucciones

3. Design and function

3.4 Isometric view

3
EN
2
7
8
1
1
2
3
4
5
6
7
Front and top
The controller, with display and controls, is located on the
front of the calibrator.
On the top of the temperature dry-well calibrator, you will find
the metal block with seven test bores for inserting the test
items.
Rear of the instrument
At the rear of the instrument, you will find the product label
with the key information about the relevant model, the serial
number, the mains voltage and the fuse rating.
4
Below the product label is the connector for the RS-485
5
interface.
6
Underside of the instrument
On the underside of the instrument are the mains connector
and the mains switch with its fuse holder.
These are located in the centre, at the front. Furthermore, on
the underside of the instrument, there is an air inlet and the
C13 panel socket for the supply of the operating voltage.
Do not obstruct the air inlet in any way!
WIKA operating instructions temperature dry well calibrator, model CTD9100-ZERO
Temperature block
Controller
Handle
Product label
RS-485 interface
Fan
C14 connector with mains filter and On/Off switch