Transport, Packaging And Storage - WIKA BCS10 Manual De Instrucciones

5. Transport, packaging and storage

5. Transport, packaging and storage
5.1 Transport
Check the calibration system for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
see chapter 3 "Specifications"
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
Store the calibration system in its original packaging in a location that fulfils the condi-
tions listed above. If the original packaging is not available, pack and store the instru-
ment as described below:
1. Wrap the instrument in an antistatic plastic film.
2. Place the instrument, along with the shock-absorbent material, in the packaging.
3. If stored for a prolonged period of time (more than 30 days), place a bag containing a
desiccant inside the packaging.
WIKA operating instructions calibration system, model BCS10
EN
13