Idiomas disponibles
Idiomas disponibles
635381-00 01 SZ360 Scissors
6/9/06
you do not get proper charging, take or send the tool and
charger to your local Black & Decker service center. See Tools
Electric in yellow pages.
5. The scissors should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT CONTINUE using product with its batteries in a depleted
condition.
6. To prolong battery life, avoid leaving on charge for extended
periods of time (over 30 days without use). Although
overcharging is not a safety concern, it can significantly reduce
overall battery life.
7. The batteries will reach optimum performance after being cycled
5 times during normal usage. There is no need to run the
batteries down completely before recharging. Normal usage is
the best method of discharging and recharging the batteries.
Operation
Switch
CAUTION: Keep fingers away from moving parts, especially the
area near the blades.
To turn the scissors ON, press the top
section of the slider switch marked (I), then
squeeze trigger as shown in figure 2 and
the tool will run. Release pressure from the
trigger and the tool will stop. Pull back on
the slider switch to lock the trigger in the
"OFF" (0) position.
Changing Cutting Heads
CAUTION: Separate the scissor blades
and set top lock slider to OFF (0) position
before removing heads.
To exchange cutting heads, grasp the
scissors as shown in figure 3, press in on
the sides of the cutting head and pull
straight out. To attach a cutting head, line it
up with the body of the scissors and push it on until it snaps into
1:39 PM
Page 5
place. If the cutting head does not line up easily, carefully separate
the blades from each other first then re-attach.
Shoe Blade
The shoe blade is recommended for cutting fabrics on a hard surface.
The large flat surface helps guide the cutting
head when following patterns.
Battery Removal
Before attempting to disassemble this tool,
turn it on and run it until it stops to ensure a
complete discharge of the batteries.
Remove the cutting head then using a phillips
screwdriver, remove the 4 screws in the product housing shown in
figure 4. Lift the batteries out and pull off the terminal clips. See
"RBRC" section below for battery recycling.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the nickel-cadmium battery (or
battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have
2
already been paid by Black & Decker. In some areas, it
is illegal to place spent nickel-cadmium batteries in the
trash or municipal solid waste stream and the RBRC program
provides an environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users,
has established programs in the United States and Canada to
facilitate the collection of spent nickel-cadmium batteries. Help
3
protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized
Black & Decker service center or to your local retailer for recycling.
You may also contact your local recycling center for information on
where to drop off the spent battery, or call 1-800-8-BATTERY.
5
4
