Idiomas disponibles
Idiomas disponibles
8. CHANGING THE MILLER
Disconnect the machine from the mains
before carrying out this operation.
To change the miller (Fig. 7) block the motor shaft using
key H, unscrew the bolt with the key G and remove
the bit. Insert the new miller until its tip is within 43
± 1mm from the face of the bolt and re-tighten this
using the key.
The millers supplied by Wegoma by Virutex are sharpened
at both ends.
9. CONTROLLING THE DEPTH OF THE GROOVE
Loosen screw K (Fig. 8) until the motor can be moved
by hand. Next turn the eccentric I with the service key
until the required measurement is obtained with the
help of the gauge J. When obtained re-tighten bolt K.
10. JOINTS
The use of Wegoma by Virutex SILICON RUBBER JOINTS
is recommended for their high resistance to bad weather
and elasticity under load at temperatures between -60°
C and 200° C.
Types of joints:
..............
1204081 Model FS1
brown Ø 8 mm.
1204181 Model FS1/B
white Ø 8 mm.
Each type of joint requires the use of the correct bit.
Refer to the table for the different types of bit.
To easily position the joints in the grooves we recommend
the use of SILICON JOINT ROLLERS (ref. 1746158). (Fig. 15)
11. MAINTENANCE OF THE
BRUSHES AND COLLECTOR
Disconnect from the mains before ca-
rrying out any maintenance operations.
Remove the screws L (Fig. 9) that hold the side covers
N and detach them from each other.
Remove the brush-holder P (Fig. 10) with small screw-
driver O, using one of the brush-holder side tabs to
lever it out. Push back the end of spring Q. Keep it in
12
1204082 Model FS2
brown Ø 8 mm.
1204182 Model FS2/B
White Ø 8 mm.
this position to extract the brush and replace it with a
new genuine Wegoma by Virutex brush. Re-insert the
brush-holder, ensuring that it is firmly positioned in
the casing and that each of the brushes exerts a small
amount of pressure on the collector.
Re-attach the covers N with the corresponding screws,
making sure that no wires get caught in the process.
It is advisable to leave the machine running for 15
minutes once the brushes have been changed.
If the collector burns or juts out, it should be serviced
by a Wegoma by Virutex service technician.
Always keep the lead and plug in good working condition.
12. NOISE LEVEL
The noise and vibration levels of this device have been
measured in accordance with European standard EN
60745-2-17 and EN 60745-1 and serve as a basis for com-
parison with other machines with similar applications.
The indicated vibration level has been determined for
the device's main applications and may be used as an
initial value for evaluating the risk presented by expo-
sure to vibrations. However, vibrations may reach levels
that are quite different from the declared value under
other application conditions, with other tools or with
insufficient maintenance of the electrical device or its
accessories, reaching a much higher value as a result
of the work cycle or the manner in which the electrical
device is used.
Therefore, it is necessary to establish safety measures
to protect the user from the effects of vibrations, such
as maintaining both the device and its tools in perfect
condition and organising the duration of work cycles
(such as operating times when the machine is subjected
to loads, and operating times when working with no-load,
in effect, not in use, as reducing the latter may have a
considerable effect upon the overall exposure value).
13. WARRANTY
All of Wegoma by Virutex portable electrical goods are
guaranteed for 12 months from the date of supply,
excluding any damage which is a result of incorrect use
or of natural wear and tear on the machine.
All repairs should be carried out by the official Wegoma
by Virutex technical assistance service.
14. RECYCLING ELECTRICAL EQUIPMENT
Never dispose of electrical equipment with domestic was-
te. Recycle equipment, accessories and packaging in ways
that minimise any adverse effect on the environment.
Comply with the current regulations in your country.
Applicable in the European Union and in European
countries with selective waste collection systems:
If this symbol appears on the product or in the accom-
panying information, at the end of the product's useful
life it must not be disposed of with other domestic waste.
