IMPORTANT SAFETY INSTRUCTIONS
ity shall be provided in accordance with OSHA 29 CFR
Part 1926.154, ANSI A10.10 Safety Requirements for
Temporary and Portable Space Heating Devices and
Equipment used in the Construction Industry or the Natu-
ral Gas and Propane Installation Codes CSA B149.1.
Periodically monitor levels of CO, CO
existing at the consturction site – at the minimum at the
start of the shift and after 4 hours.
Provide ventilation air exchange, either natural or mechani-
cal, as required to maintain acceptable indoor air quality.
Always turn off gas at the propane cylinder (liquid propane
also called liquid petroleum gas) when the product is not
in use. Disconnect the cylinder before storage.
Before storing, allow the product to cool for 30 minutes
and remove propane cylinder from the unit. Do not store
a propane cylinder attached to or near the product. If not
followed exactly, a fire causing death or serious injury may
occur.
Inspect the hose for damage before each use. If it is
evident there is excessive abrasion or wear, or the hose
is cut, it must be replaced prior to the product being put
into operation. The replacement hose assembly shall be
that specified by the manufacturer. Use only replacement
hose part no. TYQ-5B1-QG005.
This heater must be located on stable and level surface
and located away from combustible surfaces by no less
than 24 inches from rear and sides of heater and 72 inches
from above and front outlet of heater.
Never fill the propane cylinder beyond 80 percent full. An
overfilled or improperly stored cylinder is a hazard due to
possible gas release from the safety release valve. If not
followed exactly, a fire causing death or serious injury may
occur.
Only use a propane cylinder that includes a collar to protect
the cylinder valve.
If a leak is detected at any time, get away from the propane
cylinder and call the fire department.
Do not use the product until leak-tested.
Propane cylinders must be stored outdoors out of reach
of children and must not be stored in a building, garage,
or any other closed in area.
WORK AREA
Keep your work area clean and well lit. Cluttered
benches and dark areas invite accidents.
Do not operate propane heaters in explosive atmo-
spheres, such as in the presence of flammable liquids,
gases, or dust. Propane heaters create sparks which may
ignite the dust or fumes.
ELECTRICAL SAFETY
A battery operated product with integral batteries or
a separate battery pack must be recharged only with
the specified charger for the battery. A charger that may
be suitable for one type of battery may create a risk of fire
when used with another battery.
Use battery operated product only with specifically
designated battery pack. Use of any other batteries may
create a risk of fire.
Use this product only with batteries and chargers listed
Protect the power cord from being walked on or
, and existing NO
2
2
Unplug this product during lightning storms or when
PERSONAL SAFETY
Dress properly. Do not wear loose clothing or jewelry.
Avoid accidental starting. Be sure switch is in the
Do not overreach. Keep proper footing and balance at
Do not wear loose clothing or jewelry. Contain long hair.
Do not use on a ladder or unstable support. Stable foot-
PROPANE HEATER USE AND CARE
Do not use the product if switch does not turn it on or
Disconnect battery pack or extension cord from the
When battery pack is not in use, keep it away from
Keep the product and its handle dry, clean and free
To reduce the risk of electric shock, do not use this
Clean only with dry cloth.
Do not operate near any other heat sources such as
3 - English
in tool/appliance/battery pack/charger correlation
supplement 988000-302.
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the product.
when not in use.
Contain long hair. Keep your hair, clothing, and gloves
away from moving parts. Loose clothes, jewelry, or long
hair can be caught in moving parts.
locked or off position before inserting battery pack or
extension cord. Carrying the product with your finger on
the switch or inserting the battery pack or extension cord
into the product with the switch on invites accidents.
all times. Proper footing and balance enable better control
of the product in unexpected situations.
Loose clothes, jewelry, or long hair can be drawn into air
vents.
ing on a solid surface enables better control of the product
in unexpected situations.
off. A product that cannot be controlled with the switch is
dangerous and must be repaired.
product or place the switch in the locked or off position
before making any adjustments, changing accessories,
or storing the product. Such preventive safety measures
reduce the risk of starting the product accidentally.
other metal objects like: paper clips, coins, keys, nails,
screws, or other small metal objects that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause sparks, burns, or a
fire.
from oil and grease. Always use a clean cloth when clean-
ing. Never use brake fluids, gasoline, petroleum-based
products, or any strong solvents to clean your product.
Following this rule will reduce the risk of loss of control
and deterioration of the enclosure plastic.
product near water, especially when it is powered by
the power cord.
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.