American Standard PASSAGE A8010T-RHO Instrucciones De Instalación página 2

1
Ensure that the floor and stud walls are square and plumb on a
level floor as shown in Figure A. Provide a 5" x 5" (127 x127mm)
opening in the floor for the drain and refer to the product rough-in
for actual drain location. Draw a line 3-1/4" (82mm) above the
level subfloor on the wall studs at each side of the opening.
2
All of the shower bases require purchasing a round shower strainer type
drain for use with a standard 2" (51mm) plastic schedule 40 waste pipe.
Figure B shows the typical drain assembly. Before installing drain into
the shower base, remove strainer (Fig B). This will be installed after
shower base is in its final position. Cut the waste pipe height so that the
drain body will fit snug in the shower base. Apply silicone sealant
between the drain body and shower base.
NOTE: Drain not included and must be purchased separately.
24"
(610mm)
16"
(413mm)
34"
(864mm)
1"
(25mm)
2-1/4"
(57mm)
A8012T-CO
48"
(1219mm)
2-3/4"
(70mm)
ABOVE LEVEL SUBFLOOR
90°
2" (51mm)
PVC Waste Pipe
(See Product Rough-In for Drain Location)
FIGURE A
Rubber
Caulking
Gasket
Drain
Body
Silicone
Sealant
Rubber
Gasket
FIGURE B
2
MARK STUDS
90°
Opening 5" x 5"
C/L
(127 x127mm)
DRAIN ASSEMBLY
Strainer
Shower
Base
Fiber
Gasket
Locking
Nut
755467-100 Rev. A 7/18