American Standard PASSAGE A8010T-RHO Instrucciones De Instalación página 15

3) With the aid of suction cups, move first rear panel onto the wall
keeping a space of approximately 1/8" (5mm) off the surface of the
tub deck or shower base. Press panel firmly over entire surface to
ensure firm contact of panel to adhesive on wall.
NOTE: It may be necessary to brace or support the panels
against the wall until the panels stay securely in place.
See illustration 6.
4) Apply adhesive as in Step 2 and place second rear panel on wall and
snap into place of the tongue and groove of the first panel keeping
approximately 1/8" (5mm) gap between bottom of panel and tub. Do
not force or tap the groove edge to close the joint. Press firmly over
entire area of panel to securely hold in place. Wipe any excessive
adhesive that comes out between the tongue and groove with
mineral spirits.
5) Apply side panels in the same manor keeping the finished, reveal
edge to the outside or entrance of the tub or shower pan using the
same adhesive pattern. Provide a gap of approximately 1/8" (2mm) in
the corners between the side and rear panels to accommodate
adhesive. Wipe off any excessive adhesive with mineral spirits.
3
APPLYING SEALANT FOR SEAMS AND JOINTS
1) Once all panels are securely in place and set, apply the sealant
to all corners, seams between panels and gaps between bottom
panels and tub.
See Illustration 7.
NOTE: WIPE ANY EXCESS ADHESIVE FROM THE PANEL
WITH MINERAL SPIRITS.
4
INSTALLING SHOWER HANDLE & SHOWER HEAD
1) Install the shower handle and shower head per the manufacturer's instructions. Be sure to apply sealant to all trim plates.
NOTE: Allow 24 hours for the sealant to dry before use.
5
INSTALLING SHOWER SHELVES
Follow manufacturer's instructions.
IMPORTANT: Apply sealant over the threads of mounting screws AND around outside of each wall anchor to
seal out moisture and water.
The shelf/shelves must be supported to the wall behind the Passage wall panel. The Passage
wall itself must not support the weight of the shelf/shelves.
6
Install the shower door or shower curtain rod according to the manufacturer's instructions.
Illustration 6
Illustration 7
3
SUPPORT
BRACES
755588-100 Rev. 3 5/19