Idiomas disponibles
Idiomas disponibles
Interior light
To compliment the look of your collection, a LED light has been built into the bottle cooler. Simply turn the
switch button and the light comes on, turn again counteractively for off. For maximum energy efficiency,
leave light off when not viewing your collection.
Normal Operating Sounds you may hear
Boiling water, gurgling sounds or slight vibrations is due to the refrigerant circulating through the cooling
coils.
The thermostat control will click when it cycles on and off.
REVERSING THE DOOR (OPTION)
How to reverse the door
Remove the lower hinge by loosening and removing the screws with screwdriver.
Carefully lower the door and remove it.
Move the pivot pin to the opposite hole on the lower hinge.
Move the pivot pin from the left top hinge to the opposite hole on the right top hinge.
Remove the two screws from the right holes in the bottom cross bar.
Take the door. Insert the lower hinge axle into the right bottom hole of the door; make the right hole of
the door into the right top hinge axle.
Adjust the door; make it straight and in alignment with the cabinet.
Fix the lower hinge with two screws.
Cover the left holes in the bottom cross bar with two screws.
Note: As the door gasket gets pressed-in during shipment, after reversing the door the gasket might have to
be reset. This will be good for seal to avoid any air escaping. If there is a gap between the cabinet and the
door gasket, set the gasket by gently pulling it out to seal the gap. If necessary, you are recommended also to
use a hairdryer to warm the gasket to get rid of the gap.
7
