Peaq PMS210BT-B Manual De Instrucciones página 16

Size = A5
Size = A6
ENGLISH
• Danger! To reduce the risk of fi re or elec-
tric shock, do not expose this product to
rain or moisture.
• The product shall not be exposed to
dripping or splashing and no objects
fi lled with liquids, such as vases, shall be
placed on the product.
• Care should be taken so that no objects
or liquids enter the enclosure through
openings.
• No naked fl ame sources, such as lighted
candles, should be placed on the prod-
uct.
• Refer all servicing to authorised service
agent. Do not attempt to repair the prod-
uct yourself. Servicing is required when
the product has been damaged in any
way, such as the supply cord or plug
are damaged, liquid has been spilled,
objects have fallen into the product,
the enclosure is damaged, the product
has been exposed to rain or moisture,
does not operate normally, or has been
dropped.
• Before connecting the product to a sock-
et outlet, make sure the voltage indicated
on the product corresponds to your local
mains.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its ser-
vice agent or similarly qualifi ed person in
order to avoid hazard.
• Regularly check if the supply cord, prod-
uct or extension cable is defective. If
found defective, do not put the product
into operation. Immediately pull the plug.
• Place the supply cord and, if necessary,
an appropriate extension cable in such
away that pulling or tripping over it is im-
possible. Do not allow the supply cord to
hang down within easy reach.
• Do not jam, bend or pull the supply cord
over sharp edges.
16
IM_PMS210BT-B_170920_A_V04_HR.indb 16
• The power plug is used as the discon-
nect device; the disconnect device shall
remain readily operable. To completely
disconnect the power input, disconnect
the mains plug.
• The product may not function properly or
not react to the operation of any control
due to electrostatic discharge. Switch off
and disconnect the product; reconnect
after a few seconds.
• Protect the supply cord from being
walked on or pinched particularly at the
plug, convenience receptacles and the
point where it exits from the product.
• Never pull the plug by the supply cord or
with wet hands.
• Disconnect the power plug in case
of faults during use, during lightening
storms, before cleaning and when not
using the product for a longer period of
time.
• Danger! Before cleaning, switch the
product off and disconnect the power
plug from the socket.
• When the product has reached the end
of its service life, make it defective by dis-
connecting the plug from the socket and
cutting the cord in two.
• Caution! There is danger of explosion
from improper replacement of the batter-
ies. Replace batteries only with the same
or equivalent type of battery.
• Always change the entire battery pack.
Do not mix old and new batteries, or bat-
teries with diff erent charge state.
• Make sure the batteries are correctly in-
serted. Observe the polarity (+) plus / (-)
negative on the battery and the housing.
Improperly inserted batteries can lead to
leakage or, in extreme cases, a fi re or an
explosion.
20/9/17 12:02 pm