Westfalia Automotive 321 600 300 107 Instrucciones De Montaje Y De Servicio página 61

15. Koodin tai sijasta muutoksen jälkeen täytyy uudelleenkoodausdokumenttia (a back-
documentation) käyttää seuraavalla tavalla!
Aloita virheenetsintä autosysteemitestillä
Toiminta- komponenttivalinta
o
Ohjelmistokäsittely
▪
16. Kaikki: Suorita lopuksi samoin kuin alussa järjestelmätietojen kysely "Ohjatun vianetsinnän" avulla ja poista mahdolliset vikakoodit.
1. For vehicles up to the production date week 22/07 using a trailer connection unit with part number 300001506558/1K0 907 383 E or
higher, the gateway control unit -J533 must be re-flashed as follows:
Start guided troubleshooting using the vehicle system test
Function- component selection
- Bodywork
o
Bodywork - installation work
▪
All: The vehicle's gateway has to be coded as follows using a service tester to extend its functionality to the use of a towing hitch:
2.
•
Address word "19", diagnosis interface for data bus.
Select function 007 coding (service $1A) "reading/writing long code".
o
3. Passat, Octavia, Leon: On vehicles equipped with a VW parking distance control, a service tester must be used to extend the
functionality to the use of a towing hitch as follows:
•
Address word „76" Parking distance control.
Select function „07", coding the control unit.
o
4. Golf, Golf Plus, Jetta, Touran: Adapt the PDC offset value on vehicles equipped with a VW parking distance control:
•
Address word 76 (Parking distance control)
o
Adaptation
5. For vehicles from model year 2008 fitted with Park Distance Control II or Park Assist, code the control unit in the self-diagnosis using
the VAS tester:
•
Address 10 (Park Distance Control or Park Assist)
o
08 Code the control unit
Change the code value: Byte 0 Bit sample xxxxxxx1 (x: enter the available values in the entry field). To do this,
6. For vehicles from model year 2010 fitted with Park Distance Control II or Park Assist, code the control unit in the self-diagnosis using
the VAS tester:
- Vehicle self-diagnosis
o
10 park distance control II
▪
Valitse uudelleenvalinta/takaisinasennus
•
Vuonna testiohjelma tarvittavien toimenpiteiden koodi (tarvittaessa kysyä VW asiantuntija)
Trailer detection
•
Functions
o
Replace control unit for trailer detection
▪
▪ Select address word „69", trailer function.
•
Change to „Coded".
o
Continue the coding according to the menu.
▪ Set the value of the 5thdecimal place (from the right) from "0" to "1" (XX1XXXX).
•
Function „06" Exit output.
▪
Channel 2
- 0–30 cm (recommend value: 11 cm)
switch to entry mode [BIN].
008 coding
•
Master
•
008 02 clear text encoding
321 600 391 101 - 024
Select country code
•
continue with menu instructions
▪ Function „06" Exit output.
trailer → hitch detachable
-
61